Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Need another source or brand of 26 location HD D-Sub Connec

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List
View previous topic :: View next topic  
Author Message
chaskuss(at)yahoo.com
Guest





PostPosted: Tue Jun 07, 2022 8:31 pm    Post subject: Need another source or brand of 26 location HD D-Sub Connec Reply with quote

I tried to reply early on the morning of June 6. I just found a "bounce back" notice in my Spam folder, saying that my post was to large. I will reply in two parts to keep the posts under the 7 MB limit.

I think the item linked below will work. I do have one question. This item has PCB snaps. The current unit has the holes for the snaps, as does the board, but the snaps are not installed. Besides helping to secure the connector to the board, would those snaps also ground the outer shell of the connector through the snaps? Should I remove them from the below item before installation on my board?

https://www.digikey.com/en/products/detail/conec/164A18189X/2080286

Charlie


On Monday, June 6, 2022, 01:42:45 AM EDT, Robert L. Nuckolls, III <nuckolls.bob(at)aeroelectric.com> wrote:
At 05:11 PM 6/4/2022, you wrote:
Quote:
 --> AeroElectric-List messageposted by: Charles Kuss <chaskuss(at)yahoo.com>

 I need to locate and purchase a single board mount 26 location, boardmount, right angle female D-Sub connector. Mouser shows what I needas

 https://www.mouser.com/ProductDetail/CONEC/15-007623?qs=lc2O%252BfHJPVZqz3A0P8yWLA%3D%3D

  Would any of these work for you?

https://tinyurl.com/3h5yezsc

  Bob . . .

  Un impeachable logic: George Carlin asked, "If blackboxes
  survive crashes, why don't they make the whole airplane
  out of that stuff?"


- The Matronics AeroElectric-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List



20220602_161507_cropped.jpg
 Description:
 Filesize:  1.59 MB
 Viewed:  959 Time(s)

20220602_161507_cropped.jpg


Back to top
chaskuss(at)yahoo.com
Guest





PostPosted: Tue Jun 07, 2022 8:57 pm    Post subject: Need another source or brand of 26 location HD D-Sub Connec Reply with quote

My first two attempts to reply with photo attachments bounced back. So I've put the photos up on PostImage and will link them here.

https://postimg.cc/bZ4RtNVM

https://postimg.cc/pmmZrnCz

I think the item linked below will work. I do have one question. This replacement D-Sub has PCB snaps. The current unit has the holes for the snaps, as does the board, but the snaps are not installed. Besides helping to secure the connector to the board, would those snaps also ground the outer shell of the connector through the snaps? Should I remove them from the below item before installation on my board?

https://www.digikey.com/en/products/detail/conec/164A18189X/2080286

The second photo shows the underside of the board, below the D-Sub. The 3 wires soldered to the board are a kludge repair done by the bozo who damaged the D-Sub.

Charlie
On Monday, June 6, 2022, 01:42:45 AM EDT, Robert L. Nuckolls, III <nuckolls.bob(at)aeroelectric.com> wrote:
At 05:11 PM 6/4/2022, you wrote:
Quote:
--> AeroElectric-List messageposted by: Charles Kuss <chaskuss(at)yahoo.com>

I need to locate and purchase a single board mount 26 location, boardmount, right angle female D-Sub connector. Mouser shows what I needas

https://www.mouser.com/ProductDetail/CONEC/15-007623?qs=lc2O%252BfHJPVZqz3A0P8yWLA%3D%3D

Would any of these work for you?

https://tinyurl.com/3h5yezsc

Bob . . .

Un impeachable logic: George Carlin asked, "If blackboxes
survive crashes, why don't they make the whole airplane
out of that stuff?"


- The Matronics AeroElectric-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> AeroElectric-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group