MauleDriver(at)nc.rr.com
Guest
|
 Posted: Sat Sep 23, 2006 7:36 am Post subject: [Re: Isham Planetools for RV-10 kits] |
 |
|
I bought my tool kit from Isham and am quite happy. Now I'm buying
other stuff from Avery and Cleaveland.
Per Larry's advice, if you follow his link to his tool writeup you'll
see Mike's (from Alexander Tech Center) very positive writeups on the
Avery and Cleaveland tool kits. By the time I met Mike, he seemed to
think that the Isham kit might be an equally good selection.
Especially because it included the DRDT-2 and a pnematic squeezer (free
so to speak). I spoke to Isahm about the '10 and he seemed to know how
many additional clecos were initially required, the additional bucking
bar needed for the HS, etc. It seemed to be a good deal for me. It
appears that Isham has some DRDT-2 inventory set aside for him and Mike
suggested if not buying the device from him, it might be best to go
directly to the manufacturer. Only complaint I have about Isham's kit
is the inclusion (dumping) of 2" wide rivet tape. I'll probably use it
to pad my rivet gun set.
For this newbie, everyone seems to be helpful and knowledgeable. Isham,
Avery and Cleaveland have all been a pleasure to deal with. Same with
the people at the Alexander Tech Center. The Vans folks seem a bit
quirky but hey, we're married now.
Bill in Durham
Skinning the HS and match drilling the elevator
do not archive
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
