Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

A few questions, take 2

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV8-List
View previous topic :: View next topic  
Author Message
pplous(at)aol.com
Guest





PostPosted: Fri Jun 12, 2020 12:14 pm    Post subject: A few questions, take 2 Reply with quote

Matt,

The last attempt came out as random characters. Can we try again? Much obliged.


>>>>>>>>>>>>>>>>>>>>>
RV 8 listers, a few questions for your collective wisdom:


1. Did anyone wrap or otherwise protect the SCAT tubing that runs from the right wing NACA inlet to the fresh air vent in the rear seat?


2. How did you route the static air tubing from the bulkhead behind the rear seat to the instrument panel?


3. Did you install instruments or engine/ firewall forward first?


4. Anyone have a good or bad experience with an Advanced Flight Systems panel?


5. If you have rear seat rudder pedals, how did you route the cables around the rear footwells? Any trouble with getting smooth travel?


6. Has anyone used a Dynon AoA pitot tube and static air system with non-Dynon avionics?


7. Can I run coax cables for both VHF comm radios next to each other or do they need separation?


Thanks! Stay safe, sane, and healthy out there.


v/r,
P2


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
bifft(at)xmission.com
Guest





PostPosted: Fri Jun 12, 2020 2:35 pm    Post subject: A few questions, take 2 Reply with quote

Quoting pplous(at)aol.com:

Quote:
1. Did anyone wrap or otherwise protect the SCAT tubing that runs
from the right wing NACA inlet to the fresh air vent in the rear seat?

No, figured that the SCAT tubing was enough protection itself. It
isn't carrying fuel or electricity, so the worst that could happen is
it leaks air.

Quote:
2. How did you route the static air tubing from the bulkhead behind
the rear seat to the instrument panel?

Didn't route from the back seat to the instrument panel. The plans
show a forward NACA intake ahead of the panel for the front seat vent.

Quote:
3. Did you install instruments or engine/ firewall forward first? 

Did engine first and then instruments. Wouldn't have anything to hook
up the engine instruments otherwise.

Quote:
4. Anyone have a good or bad experience with an Advanced Flight
Systems panel?
5. If you have rear seat rudder pedals, how did you route the cables
around the rear footwells? Any trouble with getting smooth travel? 
6. Has anyone used a Dynon AoA pitot tube and static air system with
non-Dynon avionics?

None of these apply to my plane.
Quote:
7. Can I run coax cables for both VHF comm radios next to each other
or do they need separation? 

Coax is shielded so it should be ok. Checking Aeroelectric
connection I don't find anything recommending against it.

Brian Huffaker, DSWL
RV-8A N609HZ test flying


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
Matt Dralle
Site Admin


Joined: 08 Nov 2005
Posts: 25204
Location: Livermore CA USA

PostPosted: Fri Jun 12, 2020 3:19 pm    Post subject: A few questions, take 2 Reply with quote

Check out:

http://www.mattsrv8.com

Matt
RV-8 400+ hours

Quote:

Quoting pplous(at)aol.com:

> 1. Did anyone wrap or otherwise protect the SCAT tubing that runs
> from the right wing NACA inlet to the fresh air vent in the rear seat?

No, figured that the SCAT tubing was enough protection itself. It
isn't carrying fuel or electricity, so the worst that could happen is
it leaks air.

> 2. How did you route the static air tubing from the bulkhead behind
> the rear seat to the instrument panel?

Didn't route from the back seat to the instrument panel. The plans
show a forward NACA intake ahead of the panel for the front seat vent.

> 3. Did you install instruments or engine/ firewall forward first? 

Did engine first and then instruments. Wouldn't have anything to hook
up the engine instruments otherwise.

> 4. Anyone have a good or bad experience with an Advanced Flight
> Systems panel?
> 5. If you have rear seat rudder pedals, how did you route the cables
> around the rear footwells? Any trouble with getting smooth travel? 
> 6. Has anyone used a Dynon AoA pitot tube and static air system with
> non-Dynon avionics?

None of these apply to my plane.
> 7. Can I run coax cables for both VHF comm radios next to each other
> or do they need separation? 

Coax is shielded so it should be ok. Checking Aeroelectric
connection I don't find anything recommending against it.

Brian Huffaker, DSWL
RV-8A N609HZ test flying




--


- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List

_________________
Matt Dralle
Matronics Email List Administrator
Back to top
View user's profile Send private message Send e-mail Visit poster's website
dan.pat.b(at)gmail.com
Guest





PostPosted: Sat Jun 13, 2020 9:40 am    Post subject: A few questions, take 2 Reply with quote

I don’t get to input to very many of these questions - here is one I can comfortably answer: Re question #7 running coax cables together - I have two coax cables (RG400 - the expensive gold stuff) running together to a Garmin 480 and an SL-30 - in nearly 11 years there has never been a problem - important thing is to terminate the cables correctly - if you’re not sure ask for help - and please don’t ask how i know that
Dan Bergeron
11 years and 863 hours on RV-7A - N307TB


Quote:
On Jun 12, 2020, at 6:02 PM, bifft(at)xmission.com wrote:




Quoting pplous(at)aol.com:

> 1. Did anyone wrap or otherwise protect the SCAT tubing that runs from the right wing NACA inlet to the fresh air vent in the rear seat?

No, figured that the SCAT tubing was enough protection itself. It isn't carrying fuel or electricity, so the worst that could happen is it leaks air.

> 2. How did you route the static air tubing from the bulkhead behind the rear seat to the instrument panel?

Didn't route from the back seat to the instrument panel. The plans show a forward NACA intake ahead of the panel for the front seat vent.

> 3. Did you install instruments or engine/ firewall forward first?

Did engine first and then instruments. Wouldn't have anything to hook up the engine instruments otherwise.

> 4. Anyone have a good or bad experience with an Advanced Flight Systems panel?
> 5. If you have rear seat rudder pedals, how did you route the cables around the rear footwells? Any trouble with getting smooth travel?
> 6. Has anyone used a Dynon AoA pitot tube and static air system with non-Dynon avionics?

None of these apply to my plane.


> 7. Can I run coax cables for both VHF comm radios next to each other or do they need separation?

Coax is shielded so it should be ok. Checking Aeroelectric connection I don't find anything recommending against it.

Brian Huffaker, DSWL
RV-8A N609HZ test flying






- The Matronics RV8-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV8-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV8-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group