Matronics Email Lists

Noel,
This is a bit off topic, but have you flown with and without the ventral fin on your fox ? I am thinking of building one for my Avid if it really helps as much as I think it will. Can you get ...

I may be interested. Any Idea what you want for them?

The break was right at the toe of the weld. When I first started welding 4130 I was replacing the tail post and lower longerons on a PA12. The tail cluster was a major PITA but when I got done it lo ...

the third pic in the original post is the stub of the gear leg that broke off.. You may have to read it onthe forum for it to show.

The poly fiber and dacron are the same thing, but the dacron is not stamped, and therefore is about half the price. There is not a inside or outside you can lay it on either way.

Leonard Perry
So ...

that is fine if you want your signature on all emails you send out, not just the ones to the list

Thanks for the grove gear tips... the intent of the post was to make guys aware that there could be a crack in the the gear UNDER THE BUNGIES that you CANT SEE. This post is for those who have the bu ...

I have 20 year old outboard motor tanks that have been exposed to the sun all year. they are a bit faded, but still pliable and fully functional. This is not "new" technology, but tested, t ...

engine was shut down when the prop hit and it has a clutch, so there is no direct drive. He will check the runout on the crank just to make sure though.

Well yesterday started off great. I went out to the airport with my brother and changed out the radiator and put a shroud on it so he can control the airflow and regulate the temp. We did a runup and ...

I too went though many instructors in my initial training then for Instument training. All but one were by the book flight school goobers. I had one who said, I know who you are, who your flying budd ...

I would be VERY careful. I had to recover the rudder and elevator due to trying to bring it up to the full 350. If you read the manual (for stits covering), it states that you should not go over 250 ...

[quote="Fox5flyer"]As I recall, Pennzoil Outboard Premium Air-cooled is the recommended oil for
the Rotax 582.
Deke

Aircooled outboard ?? Been alot of years since I have seen one. I ...

I made the mistake early on in my flight training to stay away from controled airspace. I was flying in and out of a controled airport, but as soon as I hit 500' I was rolling out to the west and hea ...

--

Noel, can you please send the pics to me also

Thanks

I had a few cans that had been on the shelf for about 10 yrs. I just hit them with a power mixer for about 10 minutes and all was well..