 |
Matronics Email Lists Web Forum Interface to the Matronics Email Lists
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in| Search found 42 matches |
| Author | Message |
|---|---|
 Topic: Heated Seats |
|
| Bill Allen Replies: 9 Views: 824 |
 Forum: AeroElectric-List Posted: Sat Aug 26, 2023 1:46 pm Subject: Heated Seats |
| I fitted a seat heater in my canard pusher (engine heat is far away) and it
is fed by a separate fused feed from the main bus, via a two position “Hi-Low-Off” switch. I have an on board heurist ... |
|
| Topic: heat probe |
|
| Bill Allen Replies: 22 Views: 8983 |
Forum: AeroElectric-List Posted: Fri Nov 20, 2020 9:21 am Subject: heat probe |
| Most chip detectors fit where the drain plug goes. You can get them from
salvage yards where they break helicopters. That’s where I got mine |
|
| Topic: Cable end crimping |
|
| Bill Allen Replies: 5 Views: 2851 |
Forum: AeroElectric-List Posted: Tue May 08, 2018 6:11 am Subject: Cable end crimping |
| Replacing the wire was a possibility, but it runs so deep and long into the wing/fuselage that it would be more surgery than just replacing the section in the engine bay which had the last 4” over ... | |
| Topic: Cable end crimping |
|
| Bill Allen Replies: 5 Views: 2851 |
Forum: AeroElectric-List Posted: Mon May 07, 2018 6:54 am Subject: Cable end crimping |
| Thanks, I'll check them out.
On Mon, 7 May 2018 at 16:45, Charlie England <ceengland7@gmail.com ( Your local electrical supply house. Your local car stereo speciali ... |
|
| Topic: Cable end crimping |
|
| Bill Allen Replies: 5 Views: 2851 |
Forum: AeroElectric-List Posted: Mon May 07, 2018 5:11 am Subject: Cable end crimping |
| Following on from that, I need to extend my starter motor feed, - could anyone point me to a supplier of large but-splice connectors?
Bill Allen On Sun, 6 May 2018 at 20:39, GLEN MATEJCEK < ... |
|
| Topic: VHF antennae splitter |
|
| Bill Allen Replies: 4 Views: 1823 |
Forum: AeroElectric-List Posted: Fri Feb 09, 2018 1:37 pm Subject: VHF antennae splitter |
| Thanks Charlie,
Good points. This installation is on a composite airframe (a LongEz) and the copper dipole antennas are under the skin and thus not possible to replace without major surgery, and ha ... |
|
| Topic: VHF antennae splitter |
|
| Bill Allen Replies: 4 Views: 1823 |
Forum: AeroElectric-List Posted: Fri Feb 09, 2018 9:30 am Subject: VHF antennae splitter |
| Is there a device (a “splitter”) which can enable two VHF comms to share one antennae (not transmitting at the same time)
Bill Allen Sent from my iPad |
|
| Topic: Magic marker "robustness" |
|
| Bill Allen Replies: 17 Views: 8391 |
Forum: AeroElectric-List Posted: Sat Sep 02, 2017 4:24 am Subject: Magic marker "robustness" |
| My Sharpie story.
Some years ago, I flew my LongEz from the UK to the US and on to Mojave, where I met Burt Rutan and had him sign the fuselage with a sharpie. I was so proud of this that I covered ... |
|
| Topic: BATTERY FUSE |
|
| Bill Allen Replies: 7 Views: 5320 |
Forum: AeroElectric-List Posted: Sun Mar 05, 2017 11:01 pm Subject: BATTERY FUSE |
| I think that this maybe an example of how what is appropriate standard practice in one industry is not appropriate in another. International safety standards for autos require that, in the event of ... | |
| Topic: electrical system master contactor |
|
| Bill Allen Replies: 7 Views: 4052 |
Forum: AeroElectric-List Posted: Wed Aug 19, 2015 10:20 am Subject: electrical system master contactor |
| Good points well made.
On 19 August 2015 at 17:26, Justin Jones <jmjones2000@mindspring.com ( Electrically there is no reason a manual contactor would not work. The master contractor will go ... |
|
| Topic: electrical system master contactor |
|
| Bill Allen Replies: 7 Views: 4052 |
Forum: AeroElectric-List Posted: Wed Aug 19, 2015 7:29 am Subject: electrical system master contactor |
| Hi,
The master contactor pulls about 1.5 amps which is more than many components that "work for their living" Is there any reason why a heavy duty manual contactor could not be u ... |
|
| Topic: EAB IFR Certification |
|
| Bill Allen Replies: 13 Views: 9159 |
Forum: AeroElectric-List Posted: Tue Oct 28, 2014 10:04 am Subject: EAB IFR Certification |
| FAR 91.205 tells you what you need. It's not "Certification" - it's having your Operating Limitations re-written to include operations under IMC (and night if you want it)
here ... |
|
| Topic: brown out on start |
|
| Bill Allen Replies: 5 Views: 5184 |
Forum: AeroElectric-List Posted: Sun Oct 26, 2014 12:35 pm Subject: brown out on start |
| Hi Eric,
Do you sell the "de-slumpifier" ? regards, Bill AllenLongEz160 N99BA FD51 CZ4 G-BYLZ EGBJ On 26 October 2014 20:10, Eric M. Jones <emjones@charter.net (--> ... |
|
| Topic: Crankcase ferrous particle detectors? |
|
| Bill Allen Replies: 9 Views: 4904 |
Forum: AeroElectric-List Posted: Sat Oct 18, 2014 2:23 am Subject: Crankcase ferrous particle detectors? |
| Roger wrote <<who is “the breaker”?>>
Bob was correct, a "breaker" in The Queens vernacular would be a "salvage yard" in Americish - a quick google search turns ... |
|
| Topic: Crankcase ferrous particle detectors? |
|
| Bill Allen Replies: 9 Views: 4904 |
Forum: AeroElectric-List Posted: Fri Oct 17, 2014 10:37 am Subject: Crankcase ferrous particle detectors? |
| Hi Eric,
you wrote <<Who makes affordable crankcase ferrous particle detectors?>> I may have misunderstood this to mean a "chip detector" which I have fitted to my Lyco ... |
|
| Topic: Z13/8 Main Alternator. |
|
| Bill Allen Replies: 7 Views: 1706 |
Forum: AeroElectric-List Posted: Mon Aug 25, 2014 10:27 am Subject: Z13/8 Main Alternator. |
| And
"Why did the British fail in the personal PC market?" "Because they couldn't stop them leaking oil....." Bill Allen LongEz N99BA FD51 Cozy4 G-BYLZ. EGBJ Sent from ... |
|
| Topic: Z13/8 Main Alternator. |
|
| Bill Allen Replies: 7 Views: 1706 |
Forum: AeroElectric-List Posted: Mon Aug 25, 2014 8:25 am Subject: Z13/8 Main Alternator. |
| Hi Mike,
Haven't heard from you in a while - are you going to be at the LAA Rally this weekend? How's the Ez coming along? best, Bill On 9 April 2014 16:44, MikeDunlo ... |
|
| Topic: Z13/8 Main Alternator. |
|
| Bill Allen Replies: 5 Views: 4094 |
Forum: AeroElectric-List Posted: Thu Apr 10, 2014 10:07 am Subject: Z13/8 Main Alternator. |
| Yes, I was away Jan/Feb.
I'll be back here much more after Easter as Gary will be here then, so May/June would be a good time - call or text me? Bill On 9 April 2014 21:22, MikeDu ... |
|
| Topic: Z13/8 Main Alternator. |
|
| Bill Allen Replies: 5 Views: 4094 |
Forum: AeroElectric-List Posted: Wed Apr 09, 2014 9:30 am Subject: Z13/8 Main Alternator. |
| Hi Mike,
So you're nearly finished? Will you be flying this year? If you come past in May/June Gary Hertzler will be here again for more Ez talk :^) Bill On 9 April 2014 15:44 ... |
|
| Topic: Std density D sub pins. |
|
| Bill Allen Replies: 7 Views: 3625 |
Forum: AeroElectric-List Posted: Sat Mar 22, 2014 9:51 am Subject: Std density D sub pins. |
| Hi Guys,
Good question Tim <<what is the current rating on the Std density D sub pins?>> I'm looking at something similar right now Bob; I'm not sure I understand correc ... |
|
All times are GMT - 8 Hours |
Powered by phpBB © 2001, 2005 phpBB Group